P/N 07823341 Rev B Page 2
User Instructions
2272PB-07
Double Hood
1. Remove all System Components from their packaging, ensure they are ready for use, and lay them on a clean counter with labels facing you.
4. Attach (snap) one side
Hood-Lens mounting
hole to respective Hel-
met side mounting post.
Repeat on other side.
3. Attach (snap) center
Hood-Lens mounting
hole over Helmet cen-
ter mounting post.
5. Grasp the back of the
Hood Filter and begin
to pull the Hood up and
over the Helmet.
2. Assemble the Battery onto a double layer of Belt. Place
top edge of Belt under the Battery Clip, up to the Clip
top, so the Clip Detent rests on the Clip Base and NOT
the Belt. Place the belt comfortably around the waist
with the battery near the side-back of the right hip.
6. Continue pulling the Hood
over the Helmet down to
within about 1-2 inches from
the top rear Helmet Snap.
7. If the Hood Filter is folded over the front
Velcro Strip, “flip” the fold up to expose
the Velcro Strip. Pull the Hood down fur-
ther in back to remove the wrinkles from
the Hood Filter over the Helmet top.
8. Connect Helmet Power Cord
to Battery. Push Power
Cord Connector into Battery
Receptacle until Secure
Connection audibly clicks.
9. Loosen the ratchet
adjustment knob
counter-clockwise to
ensure the Helmet will
easily fit over the head.
Assembly and Donning - Battery, Belt, Helmet and Hood
12. Pull Hood Shrouds over top of
Helmet and down in back.
10. Pull the Helmet
over and down on
to your head.
11. Tighten Ratchet Knob (clockwise)
as tight as possible without causing
discomfort to secure Helmet on head
for all anticipated activities.
12. Pull Hood Shrouds
down all around.
13. Grasp Hood front just below Lens and Hood back just
below Filter. Pull down firmly to smooth out any wrinkles
of the Filter.
