8
DISCONNECT THE AIR SUPPLY AND EMPTY THE MAGAZINE
WHEN THE TOOL IS NOT IN USE
Always disconnect the air supply from the tool and empty the
magazine when operation has been completed or suspended,
when unattended, moving to a different work area, adjusting, dis-
assembling, or repairing the tool, and when clearing a jammed
fastener.
WHEN USING THE TOOL, BE SURE TO USE A SPECIAL AIR
COMPRESSOR AND AIR HOSE.
In order to improve its performance, it has set its working pres-
sure higher than the conventional nailers. To use the tool, you al-
ways need the special air compressor and air hose (MAX
PowerLite Compressor and MAX PowerLite Hose). Use of high-
pressure gas (for example, oxygen, acetylene, etc.) causes ab-
normal combustion, possibly resulting in explosion. Use only the
special air compressor and air hose.
NOTICE:
Frequent, but not excessive, lubrication is required for the best
performance. Oil added thru the air line connection will lubricate
the internal parts.
6. INSTRUCTIONS FOR OPERA-
TION
Read section titled "SAFETY INSTRUCTIONS".
1.
BEFORE OPERATION
1
Wear Safety Glasses or Goggles.
2
Do not connect the air supply.
3
Inspect screw tightness.
4
Check operation of the contact arm & trigger if moving
smoothly.
5
Connect the air supply.
6
Check the air-leakage. (The Tool must not have the air-
leakage.)
7
Hold the Tool with finger-off the trigger, then push the con-
tact arm against the work-piece. (The tool must not oper-
ate.)
8
Hold the Tool with contact arm free from work-piece and pull
the trigger. (The Tool must not operate.)
9
Disconnect the air supply.
2.
OPERATION
Wear safety glasses or goggles
Danger to the eyes always exists due to the possibility of dust be-
ing blown up by the exhausted air or of a fastener flying up due
to the improper handling of the tool. For these reasons, safety
glasses or goggles shall always be worn when operating the tool.
The employer and/or user must ensure that proper eye protection
is worn. Eye protection equipment must conform to the require-
ments of the American National Standards Institute, ANSI Z87.1
(Council Directive 89/686/EEC of 21 DEC. 1989) and provide
both frontal and side protection.
The employer is responsible to enforce the use of eye protection
equipment by the tool operator and all other personnel in the work
area.
NOTICE:
Non-side shielded spectacles and face shields alone do not pro-
vide adequate protection.
[AIR COMPRESSOR / AIR HOSE]
Air hose
Used at 18 to 23 bar (250 to 320 p.s.i.)
Air compressor
WARNING