HOW TO USE
How to Load Staples
1. Hold the body with one hand, push the lever down and pull the lever towards your
direction (Fig. 1).
* The pusher cannot be removed from the main body.
2. While holding the tool in one hand, insert staples into the magazine so that staples’ legs
point upward, and then set them in the pusher unit by sliding lever. You can load 604C
type of 604E type (Fig. 2).
Caution
Be sure the USE the specified tape.
NEVER apply your fingers near the front end of the magazine unit because there is a
serrated blade and the staple ejection port nearby.
Do not insert a branch near the cutting blade. Doing so may damage the cutting blade
or peripheral parts.
How to Open Tape Holder and Bobbin Case
Put your fingers on UP parts (A) (B), then open the cover (Fig. 3)
How to Load the Tape
1. Open the tape holder and bobbin case, and insert the tape roll into the bobbin case (Fig
4).
2. Pull tape into the tape holder and make sure approximately 5cm of tape hangs out of
the edge of the tape holder.
3. Load the tape through the two guides of the tape guide (Fig 5, 6).
Summary of Contents for HT-R1
Page 4: ...PARTS DIAGRAM...
