6
Wing Joining
Locate the wooden wing spar and slide
halfway into the corresponding rectangular
aperture in the wing panel, (image 9).
Please note
: the spar has a dihedral angle
and must be installed the correct way up,
(image 10).
Then fit the remaining wing panel onto the
wooden spar ensuring that none of the wires
are trapped between the panels, (image 11).
2. Horizontal Tail Plane
Secure a control horn to
one
elevator
as shown using four 1.5
x 20mm screws, (image 12).
Connect the elevator servo to
the control horn using a 75mm
control rod. The “Z” bend of the
control rod should be connected
to the servo horn, (image 13).
Secure the servo cover in
position using four 1.5mm x
6mm self- tapping screws,
(image 14).
The other side will
be completed after the tail
plane is fixed to the fuselage.
3. Vertical Fin
© Copyright Century UK Limited 2012 www.centuryuk.com
Secure the control horn to the rudder as shown using four 1.5 x 20mm screws,
(image 15). Connect the rudder servos to the control horn using the 100mm
control rod. The “Z” bend of the control rod should be connected to the servo
horn, (image 16). Secure the servo cover in position using four 1.5mm x 6mm self-
tapping screws, (image 17).
