2
1. Open the box and checking
Congratulations on choosing our products! Please carefully read this instruction manual in its
entirety and keep it well for using reference. This manual contained about the installation and the
relative using information of this products. Please according to this manual's relative speaking when
using this equipment. Instructions and warning notes written in this manual
2. Safety Introduction
Make sure that the available voltage is not higher than stated on the rear panel of the fixture.
This fixture should be operated only from the type of power source indicated on the marking
label. If you are not sure of the type of power supplied, consult your authorized distributor or local
power company.
Always disconnect the fixture from AC power before cleaning, removing or installing the fuses,
or any part.
The power plug has to be accessible after installing the fixture. Do not overload wall outlets and
extension cords as this can result in fire or electric shock.
Do not allow anything to rest on the power cord. Do not locate this fixture where the cord may
be damaged by persons walking on it.
Make sure that the power cord is never crimped or damaged by sharp edges. Check the fixture
and the power cord from time to time.
Refer servicing to qualified service personnel
This fixture falls under protection class I. Therefore this fixture has to be connected to a
mains socket outlet with a protective earthing connection
Do not connect this fixture to a dimmer pack.
LED light emission. Risk of eye injury. Do not look into the beam at a distance of less than 1
meter from the front surface of the product. Do not view the light output with optical
instruments or any device that may concentrate the beam.
If the fixture has been exposed to drastic temperature fluctuation (e.g. after transportation), do
not switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
CAUTION!
Be careful with your operations.
With a high voltage you can suffer
a dangerous electric shock when touching the wires!
