4
4
Figure 4
Before touching a screw driver thoroughly read
these instructions.
Warning/Caution:
Before installing fan, turn off
power at service panel and check all visible screws
and bolts for tightness.
1. Remove the decorative canopy bottom cover
from the canopy by turning the cover counter
clockwise. (Fig. 1)
2. Remove the hanger bracket from the canopy by
removing the 1 of 2 screws from the bottom of
the hanger bracket and loosening the other one
a half turn from the screw head. Next, turn the
canopy counter clockwise to remove the hanger
bracket from the canopy. (Fig. 1)
3. Secure the hanger bracket to the ceiling. (Fig. 2)
4. Remove hanger ball from down rod assembly by
loosening set screws, remove the cross pin and
sliding ball off rod. (Fig. 3)
5. Remove the hitch pin and loosen the two set
screws from the central shaft/top coupling of the
motor assembly. Doing so will allow the down
rod to enter the central shaft. (Fig. 4)
6. Carefully feed the fan wires through the down
rod. Align the holes at the bottom of the downrod
with the holes in the central shaft (Fig. 4).
Carefully insert the hitch pin through the holes in
the central shaft and downrod. Be careful not to
jam the pin against the wiring inside the
downrod. Insert the locking pin through the hole
in locked position. Re-tighten the set screws
against the down rod.
7. Slide the coupling cover (with wide end oriented
to floor) down the down rod. Connect the two
ground wire from the fan and inside of coupling
cover, and than fasten the secure ring using the
Allen wranch provided.
8. Slide canopy ring (with decorative side oriented
to floor) and canopy (with wide end oriented to
ceiling) onto down rod. Carefully reinstall
hanger ball onto rod. Be sure that cross pin is
in correct position, the set screw on hanger ball
is tight and that the wires are not twisted.
9. Be carefully cut open as 1 inch wide on the
downrod eubber cover use the knife, route
wires through the downrod eubber cover. Place
downrod rubber cover onto the hanger ball.
(Fig. 4)
Figure 1
Figure 2
Figure 3
Downrod
Cross pin
Hanger
ball
Set screw
5. HANGING THE FAN
Ceiling
hanger
bracket
Ceiling
canopy
Canopy
cover
Ceiling
hanger
bracket
Mounting screws
220-240V
Wires
Washers
Hook
Supply wires
Knife
Downrod
Coupling
cover
Ground
wires
Secure ring
Canopy
Canopy cover
Set screws
Hitch pin
Lock pin
Allen wrench
Downrod
rubber cover
Downrod
rubber cover
