BATTERY INSTALLATION (AND REMOVAL)
TRANSMITTER
1.
Install one 9-volt battery with polarity (+/-) as shown inside battery compartment.
2.
The 9-volt transmitter battery will last much longer than the run time of the TMH Flex-
Pak rechargeable battery pack.
BATTERY INSTALLATION (AND REMOVAL)
TRANSMITTER
VEHICLE
VEHICLE
FORWARD
REVERSE
LEFT TURN
180°/360° RIGHT
RIGHT TURN
SUPER REBOUND CONTROLS & DRIVING MODES
SUPER REBOUND CONTROLS & DRIVING MODES
1.
To remove the battery compartment cover, press the tabs as shown and lift up.
Hold the FlexPak battery pack with the labels marked 1 and 2 in the upper left-
hand corner facing up, and the metal battery contacts as shown.
2.
Holding the battery pack by its bottom half (label # 2), press the top half of
the battery pack (label # 1) flat. Now start sliding the top of the battery pack
into the battery compartment.
3.
As soon as the battery pack clears the battery latch, press the bottom half of the bat-
tery pack flat. Push the battery pack forward fully into the battery compartment.
4.
Turn the battery latch to lock the battery pack into place. Replace the battery
compartment cover.
5.
To remove: remove the battery compartment cover. Turn the battery latch to
unlock and pull the battery pack backward. Lift up the bottom half of the bat-
tery (label # 2). Slide the battery pack down and lift out.
Estimated run time for this vehicle: 20-30 minutes
Battery must be charged for 4 hours
180°/360° LEFT
Tabs
Battery
Compartment
Cover
Battery
Latch
®
