INSTALLATION
26
GB
• Do not bend your drain hose.
16. Make sure your plumbing is suitable for use with
the dishwasher. If in doubt contact a qualified
plumber. This unit MUST BE connected to COLD
WATER MAINS using the new water inlet hose.
OLD HOSE SETS MUST NOT BE RE-USED. The
water pressure from the water mains needs to
be at a minimum of 0.04 MPa and a maximum of
1.00MPa.
• Connect one end of the safety water supply
hose to your dishwasher, and then connect
the other end of the hose to your water
mains. Please ensure the black rubber seal is
in place.
• After connecting the hose, turn on your water
mains and check for leaks.
• Connect the dishwasher to the mains socket.
You may use a Y-Adaptor (not included)
for an additional water feed for another
appliance, for example a washing
machine. This is only applicable for cold
water mains. A Y-Adaptor is available
from most DIY stores.
15. To secure the dishwasher under the table top,
tighten the screws through the top sides of the
unit onto the table top.
Water mains
Y-Adaptor
(not included)
Connect
to another
appliance if
required.
Water supply hose
* images are for indication only; please refer to your individual model for actual details.
About the Safety Supply Hose
The safety supply hose consists of
the double walls. The hose’s system
guarantees its intervention by blocking
the flow of water in case of the supply
hose breaking and when the air space
between the supply hose itself and the
outer corrugated hose is full of water.
MID60B12N_IB_7L_130625_Shaun.indb 26
25/06/2013 5:56 PM