
20
GB
Starting a Wash Cycle
Please follow the steps below to start a wash cycle.
1. Ensure the unit is connected to the mains power and the water supply is on (water pressure between
0.04MPa and 1.00MPa).
2. Open the door. Pull out the dishwasher basket, load the dishes and push the basket back.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do not
slam the door.
5. Press the On/Off button.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to the
“Wash Cycle Table” (page 11).
7. The power indicator light of the selected programme indicator light will illuminate.
8. Press the Start/Pause button, the washing cycle will begin shortly.
Changing a Programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to check if the unit has dispensed the detergent or detergent tablet. This will
depend on how long the washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press the On/Off button to cancel the programme. You
may then close the dishwasher door and press the On/Off button again. Then, press the required new
programme button and confirm the selection by pressing the Start/Pause button. The unit will start
the new washing cycle shortly.
At the End of a Programme
At the end of a programme, the dishwasher will make an audible sound.
If you open the dishwasher door during the washing cycle and then close it, the dishwasher will
continue the current washing programme after 10 seconds. However, if the door is not closed
correctly after 1 minute, the dishwasher will make an audible sound at 1 minute intervals.