GB
24
Wash time too long.
During washing, if the laundry is unbalanced, the machine will
try to correct by slowly rotating the drum. This may take several
attempts. This is normal.
There’s not much foam.
• This can happen if you’ve put powder detergent directly into
the drum – you must put it in the detergent drawer.
• The amount of foam can vary, depending on the temperature,
level and softness of your water.
• You may not be using enough detergent.
• You may be using a reduced-foam type of detergent.
• Heavily soiled laundry can reduce the amount of foam.
• Larger loads of laundry can also reduce the amount of foam.
There’s a lot of foam.
• The amount of foam can vary depending on the temperature,
level and softness of your water.
• You may have used too much detergent.
• The type of detergent you use could cause excessive foam.
• Some laundry types (Bathrobe, Bath towel), hold the detergent
and becomes agitated during washing cycle. This is normal. Do
not over fill the drum.
Fabric softener overflows. • You may have exceeded the MAX level in the softener drawer.
• You may have spilt the liquid by closing the softener drawer too
sharply.
There’s a residue of
powder detergent at the
end of the wash.
This can happen if you’ve put powder detergent directly into the
drum – you must put it in the detergent drawer.
There’s an unusual noise
or vibration.
• Check that there’s no metal in the drum.
• Make sure the transit bolts used in transportation have been
removed.
• Check that the washing machine feet have been levelled
correctly.
• Check the washing machine is on a flat, stable surface.
There’s a noise when the
water drains away.
This is normal, it’s the pump starting and stopping.
The electricity supply cuts
out while the washing
machine’s on.
The washing machine will stop (do not open the door if the
machine is full of water). When the power comes back on, the
washing machine will continue the programme.
Machine is draining while
being filled.
• Install drain hose within 80-100 cm of height.
• Make sure the drain hose is not in water.
Drainage failure
• Unblock the drain hose.
• Make sure the drain hose end is lower than 100 cm above floor
level.
• Unblock the filter.
M510WM16G_IB_2L_RC_160810_grace.indb 24
10/8/16 12:05 pm
