29
Install the Memory Modules
For this mainboard, you must use 168-pin 3.3V non-buffered Dual In-line
Memory Modules (DIMMs). The memory chips must be standard or
registered SDRAM (Synchronous Dynamic Random Access Memory).
The memory bus runs at 100 MHz, you must install PC-100 memory that
also operates over a 100 MHz bus.
You must install at least one memory module. Each module may be
installed with up to 256 MB of memory so the maximum capacity is 512
MB.
1. Locate the DIMM slots on the mainboard.
Locking latches
Memory module
DIMM1
DIMM2
2. The DIMM slots are keyed with notches and the DIMMs are keyed
with cut-outs so that they can only be installed correctly. Check that
the cut-outs on the DIMM module edge connector match the notches
in the DIMM slot.
3. Push the latches on each side of the DIMM slot down.
4. Install the DIMM module into the slot and press it carefully but firmly
down so that it seats correctly. The latches at either side of the slot
will be levered upwards and latch on to the edges of the DIMM when
it is installed correctly.
