24
Chapter 4, Using Matrox RTMac with Final Cut Pro
source device’s audio sampling rate is set to 48 kHz. Check the documentation of your
source device for instructions on changing your audio sampling rate.
• Place graphics clips on one layer with less than eight frames between the
start
of each
clip, or place graphics on two layers with less than eight frames between the
end
of one
clip and the
start
of the next. To avoid rendering, place your graphics using the
guidelines shown in the following examples.
¦
Note
Non-realtime segments in the Timeline (that is, segments that require rendering) are
identified by a red rendering status bar.
At least eight frames between the
start of each clip
At least eight frames between the end of one
clip and the start of the next
Summary of Contents for RTMac
