29
9.3 deCk rePlaCemeNT
1) Remove the motor cover as outlined in Section 9.1.
2) Remove the rear roller as outlined in Section 9.2.
3) Remove the four deck screws using a 5 mm Allen wrench (Figure A).
4) Remove the deck from the running belt (Figures B & C).
5) Reverse Steps 1-4 to install a new running deck.
note:
The running deck is waxed on both sides so the opposite side surface may be
usable. New running deck surfaces must ALWAYS be matched to a new running belt.
6) Tension the running belt as outlined in Section 3.5.
fiGUre a
fiGUre b
fiGUre C
CHaPTer 9: ParT rePlaCemeNT GUide
