6
7
4. Set temperature, sheet length
and anti-curl setting.
5. Remove film mandrel.
6. Using the allen key provided, loosen
screws on the core adaptor.
Set the required temperature using the
+ - temperature buttons
MATRIX set-up & Installation of Laminating Films
7. Remove one core adaptor.
8. Slide film onto the mandrel and
centralize, replace core adaptor.
9. Place film and mandrel back onto the
machine.
10. Ensure film feeds from the bottom of
the roll.
11. Set the anti-curl device to the zero
position and ensure both laminating and
pull rollers are in the raised position.
12. Press rubber roller to drop gate and
slide in plain print, ensure it goes through
anti-curl device and into pull rollers.
1. Position the machine near a suitable 13
amp socket and plug into the mains.
2. Turn the power on.
3. Screen displayed, see large screen
diagram for functions on page 5.
13. Slide the second blank print around
the steel laminating roller, through the
anti-curl device and into the pull rollers.
14. Run the film under the idler bar and
drape over the steel laminating roller.
15. Press second set-up print onto the
film.
16. Replace the guard.
17. Ensure the micro switch is located,
otherwise the machine will not run.
18. Lower the laminating and pull rollers
and set the anti-curl to the desired
setting.
19. Set the perforation wheel, lock in
place on the edge of the film which
should be in the paper margin (and not
on the print).
20. Turn the screw as the paper is feeding
until the perforation wheel starts to turn,
then lock into position.
21. Set the guide wheel to the opposite
side of the sheet from the perforation
wheel.
22. Finally, set the incline wheel on the
edge of the print on the same side as
the perforation wheel. Only a very small
angle is required.
1. Top paper feed roller. 2. Guide paper (end).
3. Front guard. 4. Steel laminating roller.
5. Idler bar. 6. Lamination roller film. 7. Top pull roller.
8. Perforation wheel. 9. Top splitting roller.
10. Guide wheel. 11. Bottom roller for guide wheel.
12. Bottom splitting roller.
13. Perforation wheel support roller.
14. Bottom pull roller. 15. Anti-curl device.
16. Front bottom rubber laminating roller.
17. Paper stop. 18. Bottom paper feed roller.
19. Front operating panel. 20. Paper backing plate.
Place where the
paper core is stuck
to the film
1st paper core
2nd paper core
Guide paper core (front end)
