18
Installation
Important
Failure to allow adequate ventilation to the appliance may result in
overheating or damage to adjacent units and could invalidate the warranty.
The diagram below shows the minimum required.
This appliance is type X installation. The walls of the kitchen units must be
able to withstand temperatures of 75oC above ambient (typically this is
between 90oC and 100oC).
When correctly installed ensure that there is a gap of 4mm minimum
between the sides of the oven and adjacent furniture doors.
Lift the oven carefully into position on the shelf, taking care NOT to lift it
by the door handles. If you lower the oven door, you will see 4 screw holes,
2 on each side of the oven. The oven should then be secured to the housing
by fitting screws into these holes. Remember the housing should not be free
standing but be secured to the wall and/or adjacent fittings.
How to install your oven
You will need the following housing area fit your oven correctly.
MD720 only: We recommend that you fit end support panels onto the
adjacent units to allow the oven to be secured in place (as shown in fig. 6)