Ÿ
COSEC ARGO Unit
Ÿ
Flush Mounting Plate
Ÿ
4 Screws M5/25
Ÿ
4 Screw Grips
Ÿ
Overswing Diode
Ÿ
Power Adaptor 12VDC,2A
Ÿ
Power Supply Cable (with DC Jack)
Ÿ
EM Lock Cable
Ÿ
External Reader Cable
Ÿ
Flush Mounting Template
There are three different variants of COSEC ARGO depends upon the RFID
Card inserted in it.
COSEC ARGO Variants:
FOE 212
,
FOM 212
and
FOI 212
What your Package contains
COSEC ARGO Variants
Default Username:
Admin
Default Password:
1234
Ÿ
Open the Web browser in your computer.
Ÿ
Enter the IP address of the COSEC ARGO (default:
http://192.168.50.1
)
in the address bar of the browser and press the Enter key on your
computer keyboard.
Ÿ
When prompted, enter the login credentials for the Door.
Assigning IP Address and Other Network Settings
Before Wall mounting and Flush mounting of COSEC ARGO; follow the
below steps.
Ÿ
Remove the mounting screw from mounting screw hole from the
bottom of device as shown in Figure2. The screw will be required
to fix the device at the end of Wall mounting or Flush mounting.
Ÿ
Slide the back plate downwards to unlock the device from the
mounting hook and then remove it by pulling it outwards. This back
plate will be required as Wall mounting plate for Wall mounting of
COSEC ARGO. For details see Installation Instructions for Wall
Mounting.
Ÿ
The flush mounting plate is available in the package. This plate
will be required for flush mounting of COSEC ARGO. For details
see Installation Instructions for Flush Mounting.
Wall Mounting:
Select a location. It must be a flat surface such as wall,
close to the access point (door).
Flush mounting
: Select a wooden door, or a location where the duct
can be made. The rectangular duct of
has to made in the wooden door
size
in which Flush mounting plate will be installed.
For
Concealed wiring
in Wall mounting/Flush mounting, first draw out
the sufficient length of the cables from the hole of the mounting plate.
For
Non-concealed wiring
in Wall mounting; the knock -out area
has to be removed from outside by pressing on the bottom duct as shown
in Figure2.
The connection of EM Lock must be done using the diode for Back
EMF protection.
Preparation for Installation
7
8