MSC-XD3232S Product Manual
additional details.
•
General Purpose I/O
– A D25 connector provides a GPIO auxiliary port with up to 24 input or output
3.3V logic lines for control and status interfacing with external equipment (LEDs, buttons, etc). See
for more details.
1.2 Powering Up The Device
This device is not equipped with a power switch and is simply connected to the power supply adapter which is
plugged into a suitable AC power source, to power it up.
Once the device is powered it goes through the following startup sequence:
•
Reset switch is checked and if it is pressed then the
Software failsafe recovery procedure
is entered.
•
Routing matrix is initialized to Preset 0 state (defaults to source 1 connected to all destinations).
1.3 Front Status Panel
The MSC-XD3232S has a status front panel with 4 LED indicators, described in the following table:
LED Label Description
PWR
Active when power is supplied to the device.
PS 1
Power supply 1 good indicator.
PS 2
Power supply 2 good indicator.
FAULT
Red LED for user configurable faults.
Table 2: Status Panel Indicators
This model is not equipped with a built-in button control panel, however several options are available for
controlling the device, including the web page interface, telnet, RS-232 serial and remote control panels.
1.4 Web Page Interface
All Matrix Switch Corporation router and panel devices come with a built-in web page interface.
This is the recommended interface for configuration and is also a convenient way to control the matrix routing
of the device.
Devices come factory configured with default settings, unless a pre-configuration request is made during
purchase, an example being a multi device application.
1.4.1 Accessing The Web Page Interface
The default network IP address for this device is 192.168.2.60. Refer to the table below for the default IP
addresses for other types of Matrix Switch Corporation devices.
Page 8 of 60
© 2013-2019 Matrix Switch Corporation
