Technical Manual
Wireless CAN Bridge 500 (CB-500)
Matric Technical Manual 185-0053, V8
Page 4 of 12
S1
1
2
3
4
RADIO BOARD
LED CONNECTOR
6
5
S2
OFF ON
1
2
3
4
6
5
OFF ON
CONFIGURATION:
Configuration of the Wireless CAN Bridge is accomplished by manually setting switches
inside its enclosure. The CAN Bridge enclosure lid must be removed to access the
configuration switches. Users may only perform the configuration described in this
manual. Changing other switch or trimmer settings may invalidate agency approvals.
To access configuration switches, first, use a flat screwdriver to pry off the two
decorative covers at the right and left ends of the lid. Four pry slots are provided as
shown below. Then unscrew the four screws that attach the lid to the chassis of the
Wireless CAN Bridge using a philips or a flat screwdriver.
The Wireless CAN Bridge has 12 configuration switches arranged in 2 banks S1 and
S2. Each bank contains 6 switches. These switches allow the user to easily customize
the Wireless CAN Bridge to fit the desired application.
POWER
BUFFER OVERRUN
RETRY EXHAUSTED
HEAVY
MODERATE
NORMAL
LIGHT
LOADING
DATA LOSS CAUSE
STRONG
POOR
WEAK
SIGNAL
WIRELESS CAN BRIDGE
