Operation
Page 9
4
Operation
Attention!
Before starting up the implement read the instructions on safety and han-
dling for operation of the entire implement and connection to the tractor.
The snow plow is fastened to the quick-coupling triangle in the front implement of the
tractor. The two halves of the snow plow are operated from the driver's seat of the tractor
with one hydraulic cylinder for each half. In this process you switch between the two
blade halves with a electromagnetic changeover valve. The implement is equipped with
spring flaps for the safety of the driver and to protect the snow plow.
Attention!
The snow plow should not be charged with downward pressure via the trac-
tor's hydraulic system! When plowing snow the tractor hydraulic system
must be switched to the float setting!
4.1
Settings on the snow plow
Danger!
Severe injury to the operator or third parties occurs.
Switch off the tractor and remove the ignition key before making any set-
tings on the snow plow.
Safeguard the snow plow against falling with suitable aids, e.g. support
frames, mechanical lowering safeguard, etc. on the front power lift.
4.1.1
Adjusting the support wheel
&
Note!
Before each use, check the support wheel adjustment. When the snow plow
is lowered the support wheels and the scraper bar must touch the ground
uniformly.
1.
Lower the snow plow to the ground.
2.
Check the support wheel setting.
3.
Lift the snow plow and secure it with suitable aids.
4.
Switch off the tractor and remove the ignition key.