Operation and fault correction
Page 12
4
Operation and fault correction
4.1
Operation
If the snow blade is correctly adjusted, you can start working. For travel between imple-
mentation sites the snow blade is lifted via the front lift and the lowering safeguard of the
front lift is activated. To work with the snow blade, it must be lowered into float position.
Danger!
Driving on pressure is prohibited. This can make the vehicle unsteerable!
Attention!
A disabled hydraulic system can result in damage to the implement and/or
tractor!
To clear the snow to a specific side the snow blade can be pivoted via the hydraulic angle
adjustment. This setting must be made in a slightly lifted out position without load on the
snow blade. When working with the snow blade small unseen obstacles can be run over.
To protect the operator and the implement, the snow blade is equipped with spring-flap
segments. When encountering an obstacle (e.g. manhole cover) the spring-flap fold back
and the impact is reduced.
4.2
Faults
Fault:
Possible cause:
After clearing, snow still remains
Slide runner or support wheel is set too low, see 3.2
The snow blade vibrates excessively
when removing snow
Slide runner or support wheel is set too high, see 3.2
extremely uneven substrate
Tractor is hard to steer
Hydraulic system for the front lift is not in float position
The snow blade oscillates back and
forth when clearing snow
Hydraulic system for angle adjustment is not in float posi-
tion
bearings are deflected
Pendulum compensation element
moves with great difficulty
Stop nuts of the pendulum compensation element over-
tightened, see 3.4
4.3
Contact
If there are faults, problems, or other indications of malfunction,
contact your sales consultant or directly contact the manufacturer.
Enter the article number and the chassis number here.
This information is on the type plate of the implement.
Code - number: ....................................................................
Serial number: ......................................................................
