Maintenance
Page 28 of 31
5
Maintenance
5.1
General
Attention!
Personal injury or damage to the tractor and the implements can occur.
Before each use of the implements check all safety-relevant parts and the
hydraulic connections.
5.2
Service
After the first 20 hours of operation check all screw and bolt connections. Oil or lubri-
cate all moving parts. Before each use check the hydraulic connections for leaks.
Special instructions:
Front power lift
Activity
Bearing arrangement
- lift arm
– The lift arm is supported in special slide bearing shells. These bear-
ing points do not need to be lubricated, however they do need to be
checked for firm seat. If there is not a proper bearing arrangement
of the lift arm, the bearing shells of the lift arm bearing arrangement
must be replaced.
ATTENTION:
All bearing shells must always be completely
replaced!
Pendulum
compensation
– At regular intervals of at least once a month, spray a little mineral
oil into the lift arm pockets. Then move the lift arm up and down
several times.
Lift cylinder
– Lubricate the ball bearings at regular intervals, however at least
once a month
5.3
Repair
If there are faults, problems, or other indications of malfunction,
contact your sales consultant or contact the manufacturer directly:
matev GmbH
Nürnberger Str. 50
90579 Langenzenn
Tel.: (Switchboard): 09 101/90 87-0
6
Disposal
The implements must be disposed of in accordance with the applicable regulations of
the municipality or the country.
Take the parts to the collection points for residual waste, special waste, or recycle
them depending on material.
matev GmbH does not provide any disposal services.
