Matco A900 CC, Manual

Page: 13 / 56

Basics Manual
12
Cutting wire construction
(for A700 AW machine)
-
Check the condition of the glow / cutting wire
-
Check, and if necessary adjust the cutting wire to the correct tension.
-
Check whether the cutting wire is clean of dust or impurities
-
Check that the cutting wire does not come into unwanted contact with other
parts (such as cables and air hoses)
Cutting blade construction
(for A900 AW machine)
-
Check the band tension of the band cylinder.
-
If the band is not tight on the cylinder, the band must be readjusted or replaced.
Adjust or replace in accordance with the regulations of the supplier.
-
Check the condition of the band. The ribbon must not be damaged. Replace if
necessary.
-
Check the condition of the cutting blade. The cutting knife should cut and cut
through the foil. Replace if necessary.
-
Check free height space between the bottom of the cutting blade fixation arm
and the conveyor track construction. The bottom of the cutting blade fixation
arm must remain at least 5mm above the top of the conveyor track. Adjust if
necessary.