SS3K
MODEL:
Product Type:
3 PIECE OXYGEN SENSOR SOCKET SET
3 PIECE OXYGEN
SENSOR SOCKET SET
Page 1
PRODUCT INFORMATION:
Read these instructions carefully before installing,
operating, servicing or repairing this tool.
Keep these instructions in a safe accessible place.
Important
DO NOT DISCARD – GIVE TO USER
WARNING
MADE IN CHINA
Study, understand and follow all instructions provided
with this product. Read these instructions carefully before
installing, operating, servicing or repairing this tool. Keep
these instructions in a safe accessible place.
INTENDED USE OF THE TOOL
NOT FOR USE WITH IMPACT TOOLS.
This set includes sockets designed to remove oxygen
sensors and vacuum switch socket. Do not use this tool
outside of the designed intent. Never modify the tool for
any other purpose or use.
Caution: To help prevent personal injury
WARNING
• Use of this product can expose you to chemicals
including ethylene glycol, gasoline vapors and
engine exhaust, which are known to the State of
California to cause cancer, birth defects, or
reproductive harm. For more information,
visit www.P65Warnings.ca.gov. Always wear ANSI
approved safety equipment, safety glasses and
clothing when using this product. Study, understand,
and follow all instructions provided with this product.
Failure to read and follow all warnings and operating
instructions may result in damages and serious
injury or death.
• Always wear ANSI approved goggles when using
this product. (Users and bystanders).
• Never use this tool for any application other than for
which it was designed.
• Only use accessories designed for this tool.
• Never alter or modify this tool in any way.
• Improper operation and/or maintenance of the tool,
modification of the tool, or use of the tool with
accessories not designed for it could result in
serious injury or death.
• Always select the correct accessories of the correct
size and design for the job that you are attempting
to perform.
• Always work in a clean, safe, well-lit, organized and
adequately equipped area.
• Do not begin repairs without assurance that vehicle
is in secure position, and will not move during repair.
1 YEAR LIMITED WARRANTY
The manufacturer warrants this product to the original user against defective
material or workmanship for a period of 1 year from the date of purchase.
The manufacturer reserves the right to determine whether the part or parts failed
because of defective material, workmanship or other causes. Failures caused by
accident, alteration, or misuse are not covered by this warranty.
The manufacturer, at its discretion, will repair or replace products covered under
this warranty free of charge. Repairs or replacements of products covered under this
warranty are warranted for the remainder of the original warranty period.
The manufacturer or its authorized service representatives must perform all
warranty repairs. Any repair to the product by unauthorized service representatives
voids this warranty. The rights under this warranty are limited to the original user
and may not be transferred to subsequent owners.
This warranty is in lieu of all other warranties, expressed or implied, including
warranties of merchantability and fitness for a particular purpose. Some states do
not allow the exclusion or limitations of incidental or consequential damages, so
the above limitations may not apply to you.
Before Use
When unpacking, check the parts diagram and part
number listing on page 2 to make sure all parts are
included. If any parts are missing or damaged,
please call your distributor.
Vacuum Switch Socket 3/8" Dr. x 7/8" x 80mm
Designed to remove and install oxygen sensors
in most domestic and many imported vehicles.
Socket designed with slot which allows clearance
of wire. Designed to be used with 3/8" drive tool
or 1" wrench.
Heated Oxygen Sensor Socket 1/2" Dr. x 7/8" x 50mm
Socket designed with slot in socket which
accommodates the connectors on heat oxygen
sensors. Socket has a double 1/2" for easy access.
Offset Oxygen Sensor Wrench 3/8" Dr. x 7/8" x 30mm
Low profile design for use in tight spaces.
Designed to be used with 3/8" drive tool.
