Page 2
8 PIECE SOLDERING KIT
1702073-14 MA
SK8MAT
IGNITION
1. Make sure the exhaust vent is facing upward to avoid the damage of tabletop.
2. Press the safety lock button and, simultaneously using your thumb, pull down on the trigger.
This action will ignite the soldering iron.
3. Hold the ignition button and release the safety lock button.
Move the continuous flame switch to right for a constant flame.
EXTINGUISHING
Move the continuous flame switch to left, and this will cut off the gas supply and extinguish the flame.
HOT BLOWER
Disassemble the soldering tip by rotating the tip counterclockwise. The torch will now be used as
hot blower without the soldering tip. Operation will be the same as above for the soldering iron.
PENCIL TORCH
Disassemble the soldering housing by rotating the assembly lock counterclockwise. Take off the soldering
housing with the tip attached and install the metal sleeve back onto the torch. Operation will be the same
as above for the soldering iron.
FLAME ADJUSTMENT
Move the adjustment lever to the right to increase the flame strength, or left to decrease the flame strength.
When the flame is at “+” position, the longer flame may cause the torch to flare out of the exhaust port, or even
extinguish. In this situation, please move the gas adjustment lever to the “-” side to decrease the flame strength
and adjust the flame for the most effective use.
GAS REFILLING
• Upon initial use, the torch requires gas charging. Please use high quality butane (gas used by lighters).
WARNING: Refilling must be done in well-ventilated area away from flames or sparks.
• Before filling, make sure the torch is off and the flame is out.
• Let torch cool 5 minutes before refilling.
• Hold the torch upside down. Insert and press down the gas cylinders nozzle into the gas filling valve.
• A complete fill takes about 5-10 seconds.
•
Stop refilling once gas starts to overflow.
• Please allow the fuel to stabilize for a few minutes before lighting the torch.
Please read the following safety and operational information thoroughly
before using this item.
SAFETY LATCH
SOLDERING IRON TIP
CONTINUOUS FLAME SWITCH
GAS ADJUSTMENT DIAL
TRIGGER
REFILLING
VALVE
