MTCHEATEDM, MTCHEATEDL, MTCHEATEDXL, MTCHEATED2XL, MTCHEATED3XL
3
08/17/18
MTCHEATEDM, MTCHEATEDL, MTCHEATEDXL, MTCHEATED2XL, MTCHEATED3XL HEATED SOFT SHELL JACKET KIT
• Do not dry clean . Do not use dry-cleaning fluid on this heated
jacket . Do not use bleach . Cleaning solvents may have a
deteriorating effect on the insulation of the heating element .
• Maintain labels and nameplates . These carry important
information . If unreadable or missing, contact a MATCO TOOLS
service facility for a free replacement .
Inserting/Removing the Battery
• To insert the battery, slide the pack into the body of the battery
controller . Make sure it latches securely into place .
• Insert the power cable (from inside the battery controller
pocket) into the power cable port on the battery controller .
• Place the battery controller into the pocket and zip closed . If
necessary, unzip the expansion zipper to accommodate larger
battery packs .
• To remove the battery, push in the release buttons and pull the
battery pack away from the controller .
Using the USB Port
• The USB port can be used to charge a cell phone, MP3 player,
or other personal device that uses less than USB 5V 2 .1 AMPS
of electrical current . The cord can be run from the battery
controller pocket, through the grommet and channel on the
interior of the heated jacket, and through another grommet into
a side pocket . It is not recommended to use the pocket warmer
when an electronic device is charging in a pocket .
• To turn on the USB, press the USB power button . The USB port
will remain on for two hours before turning off automatically .
Operation
• The zone power buttons are located on the upper left side of
the heated jacket . Use the heated jacket and pocket power
buttons to control the two zones . To turn "on", press and hold
(1 to 2 seconds) the zone’s power button . The zone will be
turned to High and the red LED will light .
• Temperature setting can be adjusted at any time by pressing
the zone’s power button . Each press will cycle through the
zone’s temperature settings .
• To turn "off" the heated jacket, press and hold (1 to 2 seconds)
the zone’s power button . The LED will turn off .
• If the heated jacket turns off unexpectedly, check connections
and charge the battery pack .
• If the heated jacket does not start or operate properly with a
fully charged battery pack, clean the contacts on the battery
pack . If the heated jacket still does not work properly, return
the heated jacket, charger and battery pack, to a MATCO
TOOLS service facility for repairs .
To clean the heated jacket
1 . Remove battery pack and battery holder .
2 . Push the power cord completely into the battery holder pocket
and fasten closed .
3 . Machine wash, Gentle Cycle in warm water . Do not use bleach .
Do not dry clean . Do not wring or twist .
4 . Tumble Dry on Low Heat . Do not iron .
VOLT
DIRECT CURRENT
MACHINE WASH, GENTLE CYCLE IN WARM WATER
DO NOT BLEACH
DO NOT WRING OR TWIST
TUMBLE DRY, LOW HEAT
DO NOT IRON
DO NOT DRY-CLEAN
1 . Jacket and Pocket Power Button
High: Red LED
Medium: White LED
Low: Blue LED
2 . USB Battery Controller
3 . Power Cable Port
4 . USB Port
5 . Battery Controller Pocket
6 . Power Cable
