MSC4CAMO19
3
032519
MSC4CAMO19
Full Drawer Service Cart With Power Prep
HARDWARE SPECIFICATIONS
4 pcs.
4 pcs.
4 pcs.
TROUBLESHOOTING
Problem:
Drawers appear not to fit, do not slide in accurately
and bump the cart sides.
Solution:
The roller bearing slides must be fully engaged into
the mounting slots on all drawers. They potentially could fall
out of position during shipment. Check the side of the cart to
determine which slide is out of position.
Remove the drawer that is out of position. The drawer is
removed by the two clips on the actual roller bearing slide.
Simply push the roller bearing slide back down into position.
Insert the drawer back onto the roller bearing slides.
Problem:
Back Lock/Unlock Switch does not engage
the drawer.
Solution:
The inside Lock/Unlock slide potentially could fall
out of its groove during shipment. Unscrew the four screws
that are holding the Lock/Unlock slide in place.
Once the screws are removed, simply place the latch back
onto the slide and tighten the four screws back down.
Mounting Slots
16 pcs
16 pcs
16 pcs
Handle Hardware
Caster Hardware
