INSTALLATION INSTRUCTIONS - VBGL-2, VWGL-2,VAPORTITE
SAVE THESE INSTRUCTIONS
READ THOROUGHLY BEFORE INSTALLATION
WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes. Failure to do so may increase
the
RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and use so fixture failures do not cause a hazard and use only in
environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other reproductive harm. Thoroughly
wash hands after installing, handling, cleaning, or otherwise touching this product.
WARNING! Dangerous voltage exist within the unit and all precautions usually observed in handling high voltage equipment should be observed when
replacing light engine or otherwise servicing luminares. Disregarding this warning could result in electrical shock and possible injury to the individual
installing or servicing this equipment. Installation and servicing should be done by qualified personnel.
CAUTION! Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding luminaire operation and burning
position. Luminaire label shows electrical and environmental requirements and restrictions.
NOTE! This luminare is designed for outdoor lighting applications with ambient temperatures not exceeding 40°C (104°F). Use minimum 90
°C supply
wire.
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before installation or servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat retention. Dusting with a soft, clean,
dry cloth is normally sufficient for the optical system. Any accumulation of dust or dirt should be removed regularly.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any work, contact your Hubbell
Lighting distributor or [email protected] or (864) 678-1000
Give instructions to facility owner/manager for future reference.
93158367 Rev-A
Hubbell Lighting • 701 Millennium Boulevard • Greenville, SC 29607 • Phone: 864-678-1000
Due to our continued efforts to improve our products, product specifications are subject to change without notice.
© 2021 Hubbell Lighting, All Rights Reserved • For more information visit our website: www.hubbelloutdoor.com
Tools Required: Hex Key and or
Phillips Head Screwdriver. (Hex Key is
only needed on the VWGL-1 model)
#10 sized mounting screws (by others)
should be used on the mounting legs.
Silicone sealant must be used between
the mounting surface and the cast
junction box to keep water out.
Cast hole plugs have been provided
and can be removed if threaded
conduit is being used. Sealant must
be used.
GLOBE AND GUARD INSTALLATION:
Prior to tightening all screws, make
sure all wires are contained in wire
ways and no wires are pinched.
Before globe is installed, check to
make sure that gasket is replaced in
LED Housing and gasket exists on the
Globe. Screw Globe onto fixture, do
not over tighten but be sure that the
gaskets are being compressed. Place
Guard over the lens, rotate clockwise
and secure the screws. Make sure all
gaskets are positioned correctly with
no gaps to ensure that leakage will not
occur.
VBGL-2
Suitable for wet location wall mounting
or covered ceiling mounting
VWGL-2
Suitable for wet location wall
mounting
MOUNTING
LEGS
CAST
JUNCTION
BOX
WIRING
