- 11 -
4.
SET mode button with a control light for selection of function parameter.
After pushing this button we enter
a
mode,
which
allows
us
to
change
the
values
of
individual
functions.
Switching between functions is made by swinging of selector
5. If the button is activated, the LED control light
will go on.
5.
Selector for setting of welding voltage and switching between functions in the SET mode.
6.
Controls showing the display mode.
7.
Controls showing the value unit on the display.
8.
Selector for setting of feed speed and values in the SET mode.
9.
Gas test button.
By pushing this button countdown for setting of gas flow will start. The time is shown on
display 13 (pic. 5). The countdown can be terminated by repeatedly pushing the button 9 (pic. 5) or the weld-
ing torch button.
10.
Wire loading button.
After pushing button 10 the loading of wire is started. The loading process can be
stopped by pushing button 10 again or by the welding torch button.
11.
The SAVE button.
This button allows saving of the set parameters into pre-selections PrG1 to PrG20.
12.
PROG button with control.
This button serves for programs display. By pushing this button we enter the
program selection mode. The programs are chosen by selector 8. The chosen program is confirmed by re-
peatedly pushing button 12 (pic. 5).
13.
Display showing the wire feed speed, welding voltage/value and the functions status.
During welding the
display shows the welding voltage value. After termination of welding this value remains on the display for
approximately three seconds.
In an idle state the wire feed speed is displayed. During setting in the SET mode the status of the selected
function is displayed – either off or the selected function value.
14.
Display showing voltage value or the selected function type.
During welding and three seconds after its
termination the display shows the welding voltage value. After welding termination, the value remains on
display for another three seconds. In the SET mode the abbreviation of the function currently being set is dis-
played.
15.
The temperature indicator light.
The temperature indicator signals the machine overheating.
16.
The input voltage indicator.
The indicator light is on when the input voltage is out of range.
17.
The indicator inverter ON.
The indicator is on when the output part of the machine is running.
Function SYNERGIC
Activation of synergic function
Press button PROG (pos. 12) and by switch 8 choose one of synergic programs.
Description of synergic programs is on page 82.
