9
8a
8b
11
SECTION HEADLINE
8
STAINLESS STEEL WET/DRY VACUUM WITH TWO-STAGE MOTOR 054-0239-6
GENERAL ASSEMBL
Y INSTR
UCTIONS
1. Ensure that the power cord is disconnected from the power outlet (Fig. 1).
2. Undo the clasps (Fig. 2).
3. Lift the top section off the tank (Fig. 3).
4. Remove the contents from inside the tank (Fig. 4).
5. Turn the container upside down. Insert the two casters into the sockets on the bottom of the base and
apply pressure until casters snap into place (Fig. 5).
6. Fitting the wheels, see below for detail description (Fig. 6).
7. Position the hose storage rack as illustrated. Insert one side of the rack into the channel, making sure it
is secured in place. Squeeze in the other end and insert it into the corresponding channel, making sure
it is secured. (Fig. 7a & 7b)
8. For dry vacuum cleaning, install the supplied cartridge fi lter and dust bag. (Fig. 8a - 9).
9. In order to increase the operation cycle, please use the cloth pre-fi lter when using for dust cleaning. This
cloth pre-fi lter can prevent fi ne dust from blocking the cartridge fi lter, and prevent damage from
abrasive dust. If cloth pre-fi lter is wet, please dry it before use. Please do not use this cloth pre-fi lter on both
sides. (Fig. 10).
10. For wet vacuum cleaning, install the supplied foam fi lter (Fig. 11).
11. Replace the top section on the tank (Fig. 12).
