MIC 1 MIC 2 INPUTS
– Two female XLR sockets enable two microphones to
be connected with male XLR sockets.
MIC ON
- Two MIC ON buttons enable a pair of microphones to be used
on CH1 & CH2 by pressing each MIC ON button. The microphone signal
is attenuated in the same way as a Phono or Line source (see
TRIM &
CH1-CH4 ROTARY FADER
paragraphs shown in the
FRONT PANEL CONTROLS
section). To switch off a MIC input press the MIC ON button.
Using the external
Send & Return System
Connect the Mixer Aux Send outputs to the FX unit inputs and connect
the FX unit’s outputs to the mixer Aux Returns. Set the FX unit to
unity gain.
Turning up the mixer channel send control feeds the channel signal to
the FX unit. This signal is processed by the FX unit and its output is
fed back into the mix, adding an echo, delay, reverb, or other effect
to the track that’s playing. Turning down the mixer channel send
stops the channel signal feeding to the FX unit and so also stops the
effect. Turning up the mixer channel send increases the level of FX.
Normally the feed to the channel AUX send is also controlled by the
channel fader, so turning down the fader also turns down the level of
FX. However if the AUX send PRE button is pressed, the AUX send takes
its signal before the Channel Fader so the channel signal can be sent
to the FX Unit even if the fader is off. This can be a cool way to
mix into a new track: introducing a low level delay of the track you
are about to mix into, before mixing in the new track by bringing up
the channel fader.
MIX INSERT
– The Radius 4V & Linear 4V incorporate a unique feature
that allows the Aux Return Jack Sockets to be reconfigured as a Mix
Buss Insert point, just by pressing the INSERT ON button. This allows
you to run the entire mix though an external FX processor or other
device, such as a compressor, limiter or graphic equaliser. With
the button pressed the two ¼” TRS Jacks become a conventional mixer
Insert, with the Tip being the SEND, and the Ring being the RETURN.
Linear 4V Radius 4V
Operation Manual
Rear panel controls
9
