8
Do not place the power unit in an area of extreme heat or cold. It works best
at normal room temperature. The base of the tool or power unit may become
warm during charging.
WARNING!
Only use the original power unit to charge the tool; use of
other power units may cause fire, explosions, and serious injury.
NOTE: During the charge, the tool can’t be turned on.
FITTING SCREWDRIVER BITS
Place a 1/4” bit into the magnetic bit holder and then insert the bit holder into
the screwdriver collet.
Note: Your drill is intended for light-duty use.
For best results, 1⁄4”
screwdriver bits are recommended.
Never engage the trigger switch when changing screwdriver bits.
Always lock the trigger switch when changing drill bits. (See forward/reverse
switch instructions.)
FORWARD/REVERSE SWITCH
The forward/reverse switch
determines the running direction
of
the tool and also serves as a trigger
switch lock.
To select the “forward”
motion,
release the trigger switch and push
the forward/reverse lever to the right
side of the tool. To select the “reverse”
motion, push the forward/reverse lever
to the left side of the tool.
The center position of the switch
locks the tool in the “OFF” posi-tion.
When changing the position of the switch,
be sure the trigger is is not
depressed.
WARNING!
Charging time must not exceed 15 hours; the battery may be
damaged with excessive charging. Avoid charging your screwdriver in freez-
ing conditions. The power unit provided must only be used with this screw-
driver and not with any other products.
Do not insert metal objects into the power unit.
Never change the forward/reverse switch while the screwdriver is rotating,
as this will damage the screwdriver.
FORWARD REVERSE
SWITCH LOCKED
IN CENTER POSITION
Fig. 2
