MasterForce 241-0400, Operator'S Manual

Page: 16 / 26

16
BATTERY FULL
After fully charged, the green LED Light on the charger will be on and the red
LED light will be off.
NOTE:
The battery pack will fully charge, but will not overcharge, if left on the
charger.
NOTE:
The power indicator LED lights will not be displayed when the power
indicator button pressed while the battery pack is still on the charger.
NOTE:
Charger may warm with several continuous charge cycles. This is part
of the normal operation of the charge. Charge in a well ventilated area.
TO ATTACH BATTERY PACk (Fig. 5)
1. Lock the trigger switch on the
drill by placing the direction of
rotation (forward/reverse/center
lock) selector in center position
2. Align the raised portion on the
battery pack with the grooves on
the bottom of the drill, and then
attach the battery pack to the drill
as shown.
3. Make sure the latch on the
battery pack snaps into place and the battery pack is secured to the drill
before beginning operation.
TO DETACH BATTERY PACk (Fig. 5)
1. Lock the trigger switch on the saw by placing the direction of rotation
(forward/ reverse/ center lock) selector in center position.
2. Depress the battery release buttons located on the front of the battery
pack to release the battery pack.
3. Pull forward on the battery pack to remove from the tool.
CAUTION: when placing battery pack on the tool, be sure that the raised
rib on battery pack aligns with the groove on the saw and the latches snap into
place properly. Improper assembly of the battery pack can cause damage to
internal components.
TRIGGER SWITCH (Fig. 6a)
To turn the drill/driver ON, depress the trigger switch. To turn it OFF, release
the trigger switch.
VARIABLE SPEED (Fig.6a)
ATTACH
Fig. 5