A
BOUT
T
HE
W
IDE
A
REA
V
ACUUM
O
PERATION
AND
C
ARE
I
NFORMATION
This vacuum is designed to efficiently
clean large areas of carpets. It also per-
forms very well on hard surface floors.
The heavy duty motor provides power for
the brush and rotating fan. The large
capacity filter bag, foot switch and foot
pedal for nozzle height adjustment pro-
vide convenient operation.
The Chevron pattern brush pushes dirt
toward center of the brush and vacuum
inlet for pickup.
In areas where more than average dirt
is present, it is recommended that a
second pass be made over the surface.
Back up the vacuum to lift carpet nap,
thus helping to remove the heavy, deep
dirt or sand.
This vacuum must be connected to the
correct power source to correspond to
the data on the name plate.
1}
When removing the dust bag or
inspecting the blower fan and brush, dis-
connect power cord plug from the wall out-
let.
2}
The brush belt guard and thread guard
are designed to prevent threads and
strings from binding the brush. Inspect
the brush frequently for obstructions and
removed them to prevent damage to bris-
tles.
3) DO NOT
pickup large metal slugs, metal
shavings or similar debris. Also, care must
be taken so as not to suck up loose carpet
or other such bulky articles.
4}
When the vacuum is not in use or in
storage, to prevent damage, lift brush bris-
tles off the floor.
5}
Wrap the power cord around the han-
dle when the vacuum is not in use.
6}
The vacuum handle can be stored in the
full vertical position or folded down flat in
the vertical positioned for packing.
7}
Periodically the motor should be
cleaned out using compressed-air.
Especially when used on new carpet or in a
dusty area.
1}
Remove the wide area vacuum from the
carton.
2}
Flip the handle up into the upright posi-
tion and secure in place with the speed pin
attached to the handle bracket.
3)
Remove cloth filter bag from the carton
and attach it to vacuum with zipper, facing
the front of the unit. Stretch mouth of the
bag completely over discharge port on
bact of vacuum.See fig 2.
4}
Assemble the hose and bag adaptor to
the cast discharge deflector at rear of the
vacuum, with bag adaptor facing front of
unit. See fig 2.
5}
Install a paper filter bag to the bag
adaptor by grasping the bag’s cardboard
collar, pulling it forward on to the adaptor.
6}
Zip up the filter bag and secure it to the
handle with wrap-around velcro strap.
O
PERATION
I
NSTRUCTIONS
P
AGE
5
