model no. 062-3424-6 | contact us 1-800-689-9928
10
OPERATING INSTRUCTIONS
NOTE:
• The pump must be filled with water
before operation. Running the pump dry
will cause damage to the shaft seal and
will void the warranty.
• Add thread tape on the discharge tee
cap a. Remove the prime plug (1) and
the discharge tee cap (2). Fill water into
top of discharge tee (3) until pump
overflows with water. Reinstall the prime
plug (1) and the discharge tee cap (2)
when finished priming.
• This pump is not designed to be used with under-ground pop-up sprinklers (zoned
systems) If you have this type of system, purchase a higher capacity lawn or
irrigation pump.
Usage: You can install a 100# pressure gauge (sold separately) on
top of the discharge tee cap in order to monitor pressure.
Priming the Pump:
Running the Pump:
1
2
DANGER:
Risk of electric shock. Always disconnect the electrical supply before attempting to install, service, or
perform any maintenance. If the power source is out of sight, lock and tag in the open (OFF) position to
prevent unexpected power application. Failure to do so could result in fatal electric shock. Only qualified
electricians should repair this unit. Improper repair could result in fatal electric shock.
A
1
2
3
WARNING:
Let the pump cool for at least 20 minutes before attempting to service. The motor may be extremely hot.
Personal injury may result.
a. Plug the power cord into a
GFCI-protected electrical outlet
and press the power switch to
the ON position. If the pump
does not pump water with in
2 minutes, turn the pump (A)
off. Refill with clean water and
make sure all connections are
air tight. To turn the pump off,
press the power switch to the
OFF position.