7
INSTALLATION PREPARATION
Estimated Assembly Time
(new installation): 5 minutes
Materials Required for Assembly
(not included): Garden Hose (50'/15.2 m max. length)
Do not suspend the pump by the discharge hose or power cord.
• Keep the pump suction strainer clear.
• Do not install pump directly on sand or dirt.
Add water (approximately
1 – 2 Tbsp/15 – 30 mL) into
inlet to wet the impeller of
the pump (A).
INSTALLATION INSTRUCTIONS
NOTICE:
Make sure the connection is
airtight. An air leak can cause the pump (A) to
run dry.
1
Thread the other end of the suction hose
(C) to the suction inlet of the pump (A).
NOTICE:
Always ensure the washer in the hose
bib is not damaged. An airtight seal is necessary for
this pump to operate.
Make sure the suction hose (C) and
suction strainer (B) are in the water
before plugging in the pump (A).
3
2
C
A
C
A
C
B
Attach suction hose (C) by pushing the
male threaded end into the rubber
suction strainer (B). Then, place the
strainer in at least 1/2" (12.7 mm). of
water at the lowest point to be
pumped.