12
13
model no. 055-3505-2 | contact us 1-800-689-9928
Setting the tool rest at a specific angle
(Fig. 4 and 5)
1. Insert the angle gauge
(1)
into the slot
(2)
next to the
wet wheel.
2. Loosen the tool rest handles
(3)
, and align the tool
rest
(4)
with the desired angle line
(5)
on the gauge.
3. Tighten the tool rest handles
(3).
4. Make sure there is a distance of approximately
1/16” (1.6 mm) between the wet wheel and the tool
rest.
Installing the dry wheel tool rest
(Fig. 6)
1. Insert the bolt
(1)
through the L-shaped metal bracket
(2)
and through the dry wheel tool rest support
(3)
at
the front of the sharpener. The metal bracket should
be in front of the dry wheel.
2. Place the washer
(4)
and the handle
(5)
over the bolt,
and turn the handle clockwise in order to tighten it.
Installing the dry wheel eye shield
(Fig. 7)
1. Place the coiled portion of the plastic eye shield
(1)
into the spark deflector
(2).
2. Position the spark deflector with the plastic eye shield
between the right and left supports
(3).
3. Insert the bolt
(4)
through the supports,the spark
deflector, and the eye shield.
4. Place the washer
(5)
and the knob
(6)
on the bolt,
and tighten the knob in order to secure the shield.
Adjusting the dry wheel tool rest and eye
shield
(Fig .8)
1. Turn the dry wheel tool rest handle
(1)
coounterclockwise in order to loosen it.
2. Move the metal tool rest
(2)
to the desired position.
Maintain a distance of approximately 1/16” (1.6 mm) between the wheel and the tool rest.
3. Turn the tool rest knob
(1)
clockwise in order to tighten it and secure the tool rest in place.
4. Turn the eye shield knob (3) counterclockwise in order to loosen it. Move the eye shield (4) to the
desired position, and tighten the eye shield knob.
Water reservoir
The wet sharpening stone absorbs water during use. This
helps to prevent heat build-up that can dull hardened steel
edges. Check the water level periodically, and refill the
reservoir with regular tap water as needed.
Filling the water reservoir
(Fig. 9)
1. Using a measuring cup, slowly and carefully pour
approximately 3 oz (90 ml) of water into the reservoir
(1).
The water level should be below the drain lip
(2).
2. Turn the sharpener on for approximately 30 seconds in
order to allow the sharpening wheel to absorb water
from reservoir.
Draining the water reservoir
(Fig. 10)
1. Turn the sharpener off, and unplug the power cord.
2. Lift the sharpener up and tip it in order to pour water
out of the reservoir through the water drain lip
(1).
ON/OFF switch
(Fig. 11)
Press the switch (1) to the “ON” position
(1)
in order to start
the wet/dry sharpener. before using the sharpener, allow
the wheels to turn for a few seconds in order to reach full
speed.
Press the ON/OFF switch to the “OFF” position (O) in order
to stop the wet/dry sharpener.
NOTE:
If your tap water is “hard”, use distilled water to fill the reservoir.
NOTE:
Do not overfill. Excess water will overflow from the drain lip.
ASSEMBL
Y
AND
ADJUSTMENTS
ASSEMBL
Y
AND
ADJUSTMENTS
4
5
1
2
3
4
5
2
3
6
5
1
4
1
2
4
3
1
2
1
1
