headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
16
model no. 054-6821-2 | contact us 1-800-689-9928
MICRO-ADJUSTMENT WITH THE DEPTH ROD AND DEPTH-STOP TURRET
The depth rod has a micro-adjustment knob that turns a screw (inside the rod) either clockwise or
counter-clockwise to lower or raise the depth rod on the turret for micro-adjustment of the plunge
depth.
Each complete revolution of the micro-adjustment knob adjusts the plunging depth by approximately
1/32” (0.8 mm). A reference indicator line is marked into the depth rod under the micro-adjustment
knob to set a reference point of “0”.
When adjusting the plunge depth, always make sure that the micro-adjustment knob has been turned
down (clockwise) several revolutions from the top before setting the depth rod and depth-stop turret.
To use the micro-adjustment knob after the depth rod and turret have been set, check the final depth
setting and micro-adjust as follows:
• To micro-increase the plunge depth, raise the micro-adjustment screw by turning the knob counter-
clockwise to the desired amount.
• To micro-reduce the plunge depth, lower the micro-adjustment screw by turning the knob
clockwise to the desired amount.
TOGGLE “ON/OFF” SWITCH
(fig 12)
Your router motor is turned “ON” and “OFF” with the
toggle switch located on the top cap of the motor
housing. The left side of the toggle switch hood (as
you face it) is marked “I” and “ON” and the right
side (as you face it) is marked “O” and “OFF.”
1. To turn the motor “ON”, push the toggle switch to the
left side marked “I” and “ON.”
2. To turn the motor “OFF” push the toggle switch to
the right side marked “O” and “OFF.”
Always hold the router and the cutter bit away from the workpiece when turning the toggle switch
“ON”. Only contact the workpiece with the router and cutter bit after the router has reached the full
selected speed. Only remove the router and cutter bit from the workpiece after turning the router motor
“OFF” and after the cutter bit comes to a complete stop.
SOFT START
The soft start-control minimizes torque twist, customary in larger router motors, by limiting the speed
at which the motor starts. This increases the motor’s life.
OPERA
TING INSTRUCTIONS
fig 12
