headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
11
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
WARNING!
• Tighten the collet securely to prevent the cutter bit from slipping. If the collet is not securely tightened, the
cutter bit may detach during use, causing serious personal injury.
• Do not use a cutter bit that has a diameter larger than the two sub-base openings [1 7/32” (31 mm)].
A larger cutter bit will not fit through the sub-base opening, will cause damage to the sub-base and the
motor, and could cause serious personal injury to the operator.
FPO
INSTALL THE CUTTER BIT
(fig 2)
1. Turn the motor off and unplug the router from the
power source.
2. Remove the motor housing from the fixed or plunge
base.
3. Set the motor upside down on its top cap, with the
collet pointing up.
4. Press the spindle-lock button to engage and lock the
spindle shaft and the collet. Place the wrench on the
collet and turn it counter-clockwise to slightly loosen
the collet to accept the cutter-bit shank.
5. Insert the cutter-bit shank into the collet assembly as far as it will go, then back the shank out until the cutter
is approximately 1/8 to 1/4” (3.2 to 6.4 mm) away from the face of the collet.
6. With the cutter bit inserted and the spindle-lock button pressed in to engage the shaft, place the wrench on
the collet and turn it clockwise until the collet is firmly tightened on the cutter bit.
REMOVE THE CUTTER BIT
1. Turn the motor off and unplug the router from the power source.
2. Remove the motor from the fixed or plunge base.
3. Set the motor upside down on its top cap, with the collet pointing up.
4. Press the spindle-lock button to engage and lock the spindle shaft and the collet. Place the wrench on the
collet and turn it counter-clockwise to loosen the collet slightly.
5. Remove the cutter-bit shank.
fig 2
OPERA
TING INSTRUCTIONS
NOTICE:
• If the cutter bit cannot be removed, you can remove the collet and bit together and then knock the bit out from the collet.
• To ensure proper gripping of the cutter-bit shank and minimize run-out, the shank of the cutter bit must be inserted into the collet
at least 5/8” (15.9 mm).
Cutter
Bit shank
Spindle-
lock
button
