MasterCraft 054-4892-4, Instruction Manual

Page: 14 / 24

headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
model no. 054-4892-4 | contact us 1-800-689-9928
14
OPERATING INSTRUCTIONS
REPLACING THE COLLET (FIG. A)
Six sizes of collets are provided to accommodate the
different accessories shank sizes.
Press the spindle lock button (2) and turn the collet
nut (1) counter-clockwise with the supplied wrench.
Remove the collet nut and inner collet, and then insert
one appropriately-sized collet into the spindle. Reinstall
the collet nut to finger tight. Do not over-tighten the
collet nut when there is no accessory in the collet.
Finally release the spindle lock button.
FITTING AN ACCESSORY (FIG. B, C)
Press the spindle lock button (2) and turn the collet nut
(1) counter-clockwise with the supplied wrench. Then
insert the mandrel of the accessory into the collet. Use
the wrench to turn the collet nut clockwise until lightly
tightened. Do not over-tighten.
Finally, release the spindle lock button.
OPERA
TING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book carefully.
Fig. A
Collet Collet nut
Fig. C
Fig. D
a b
ON OFF
Fig. E
Fig. F
Fig. G
Fig. H
Fig. I
Fig. D
Fig. B
1
2
3
1
2
1/4" (6 mm)
FPO
FPO
WARNING:
Make sure to fully tighten the collet nut before operation. Always use the collet which
matches the shank size of the accessory you plan to use. Do not force a small diameter
shank into a large size collet.
WARNING:
Do not engage the spindle lock button while the tool is running.