headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
6
model no. 046-8652-2 | contact us 1-800-689-9928
headline bars
continuation tabs
notes
warnings
INST
ALLA
TION INSTRUCTIONS
WARNING!
The gear rack must be installed into wall studs. It is the responsibility of the
installer to ensure that wall mounting surface and structure are sufficient in strength and capacity to
support the weight of the gear rack and its contents. Failure to observe these conditions may result
in injury or death. Locate your studs. You should have studs located 48’’ (122 cm) apart. If this is
the case, use lag bolts to screw through holes in parts MD into wall. If your studs are not a standard
width, use the holes in the backplate MH.
FPO
Assemble MD, MD, MH as shown below and tighten bolts lightly as you will remove these to
install parts in steps 3 and 4.
1
2
Find your studs and predrill (use 5 /32’’ drill bit) one top hole, and screw in using your
ratchet. Level, predrill and install the other side. Continue installing four other bolts to studs.
Use these holes to install if your studs aren’t
exactly 48” (1.22 m) apart.
x 2 BB
MD
MH
MD
x 2 CC
Dimensions : 48 x 18 x 18”
(121.92 x 45.72 x 45.72 cm)
6 X AA
