model no. EH-4604BY | contact us 1-800-689-9928
8
Figure 3a:
Single Screw
Figure 3b:
Double Screw
Figure 4
INSTALLATION INSTRUCTIONS
HARDWARE NEEDED
You will need the following hardware, which can be purchased from your local hardware
store or electrical supply house:
• Adequate gauge and length of wire for your application.
• Proper size fuse or breaker to handle amperage.
• Proper wire connectors for your application.
• Fasteners appropriate for application that are strong enough to hold the unit.
MOUNTING THE HEATER ON THE CEILING
1. Locate a wood stud in the wood ceiling joist. If you cannot locate a wood stud, you
have to install a wood piece on the ceiling as this heater must be securely fastened.
2. Remove the mounting bracket from the heating unit by loosening bracket screws
with a wrench and slipping the handle off over the screw heads.
3. Place a washer on screws before inserting through the holes in the mounting
bracket and screw them securely into a ceiling joist.
HANGING THE HEATER
1. Lift the heater up and into the mounting bracket.
2. Align the bracket screws with the keyhole slots in the mounting bracket.
3. If the heater is to be tilted it must be positioned in the keyhole slots
—
see Figure 4.
4. Tighten the bracket screws with a wrench so the unit is securely suspended at
horizontal or vertical level.
NOTE:
If you want to swivel the heater either to the right or left, adding a washer to both sides of the
bracket is recommended. A longer lag bolt may be required to properly secure the unit. See Figure 3a.
INSTALLATION INSTRUCTIONS
WASHER
BRACKET
3
/
8
’’ DIAGONAL
LAG BOLT
3
/
8
’’ DIAGONAL
LAG BOLT
WASHER
BRACKET
Keyholes
Bracket Screws
REMOVE SCREW TO COVER
USE BOTTOM
KEYHOLE SLOTS
IF HEATER IS TO
BE TILTED DOWN
