Integrity Bath
–
Model MB-80
R
Operation Manual
07-06-18
Page 8 of 16
450 East 32nd Street, Fremont NE 68025
800-798-5867 FAX: 402-563-9102
www.mastercarebath.com
Bring the water temperature up to normal bath
temperature by placing the shower wand inside the bath,
turned toward the tub side wall. Then turn on the
SHOWER
WAND CONTROL VALVE
. Run the water until it reaches the
desired temperature; adjust the water temperature
between 96° to 105° by turning the
MIXING VALVE
toward
the hot or cold side. Turn off the
SHOWER WAND CONTROL
VALVE
and replace the
SHOWER WAND
. Close the drain by
rotating the DRAIN HANDLE. Slowly turn the
TUB FILL VALVE
open and test the water temperature again with your
hand to make sure it is safe and comfortable for the
individual. Check the temperature of the water by reading
the
TEMPERATURE
THERMOMETER
. Adjust water
temperature following the above instructions if needed.
Fill to just below the
OVERFLOW,
then turn the fill valve off.
Dispense Bath Oil into the water by pushing the
BATH OIL
BUTTON
on the side of the tub as outlined on page 13.
The temperature of the bath water must never
exceed 110°. If you are unable to adjust to the
normal level of 96° to 105°, remove the individual
and report the problem to maintenance. Do not use
bath until the mixing valve is serviced to correct the
problem. Failure to heed this warning could result in
a scalding injury to the individual.
9. Shampoo & Body Wash:
During the normal bath cycle you can shampoo the
individual’s hair and wash their body with MasterCare’s
specially formulated Shampoo and Body Wash. Simply
push the touch pad as you are filling the bath to add the
Bath Oil directly into the bath water. Hold your hand
under the dispensing portal to receive the shampoo/body
wash in your hand. Bathe the individual with their hygiene
needs. To rinse, lift the
SHOWER WAND
from its holder,
located on the tub deck, and then direct the nozzle
towards the open water in the tub. Turn the
SHOWER
WAND
on by turning the
SHOWER WAND CONTROL VALVE
counter clockwise to full open. Adjust the shower water
temperature to the desired individual comfort level using
the
MIXING VALVE CONTROL VALVE
. Test the water
temperature on your wrist before showering the
individual. Turn off
SHOWER WAND CONTROL VALVE
when
complete by turning knob clockwise. Return
SHOWER
WAND
to its holder.
10. End of Bath Cycle:
At the end of the bath cycle, while leaving the BathAire
(SM)
on, open the drain by pulling up on the Drain Open/Close
Lever. Dry as much of the individual as you can before
removing them from the tub.
LIQUIDS
DISPENSING
BATHAIRE VARIABLE
SPEED CONTROL
ON/OFF
MORE AIR/HEAT
LESS AIR/HEAT
WAVE
Shower Wand
Service Access
Door
Door Seal
Open/Close Arm
Tub Door
Reservoir
Disinfectant
Wand
BathAire Control
Panel
Shower On/Off
Valve
Mixing Valve
Reservoir Fill
On/Off Valve
Tub Fill Lever
Fill
Temperature
Bath Water
Temperature
Door Latch Release
Button
