Entrée Bath Gen III
INSTALLATION MANUAL
01-27-2022
Page 5 of 9
450 East 32
nd
Street PO Box 1022 (68026)
Fremont NE 68025
800-798-5867 Office: 402-564-5867 FAX: 402-563-9102
www.mastercarebath.com
INSTALLATION CHECK LIST
1.
Upon Receipt:
Immediately upon receipt, check for visible freight
damage. If damage is found, or Shock & Tip Tag is altered,
do not accept delivery.
It must be reported, communicated and documented
immediately to the freight company and MasterCare 1-
800-798-5867. Proceed to inspect the tub for hidden and
concealed damage. Leave the tub on the pallet until ready
for installation. If the tub is going to be stored for a period
of time before installation, cover it with a tarp to protect
it from dust and construction debris.
2.
Entree Bath Uncrating Instructions:
(Note: Read and
follow instructions thoroughly. Refer to the drawing on
following page to reference details.)
1.
Remove the stretch wrap (plastic) from the outside
of the crate.
2.
Remove the ten (10) lag screws from the bottom of
the crate (Detail 1).
3.
Two people will now be required to lift the crate
over the top of the Entree Bath.
4.
Set aside the Entree Gen III Starter Kit box and the
Combo Case from the pallet.
It is recommended to
leave the stretch wrap (plastic) on the Entree Bath
until the tub is in its final location.
5.
Remove the two (2) 10-
32 x ¾” thumbscrews from
the Entree cover panel (Detail 4). Gently remove
the cover panel from the tub.
CAUTION
:
Remove the cover panel before removing the tub
from the crate
.
6.
Locate the Tub Power Cord, center rear back of tub,
then plug in the tub and close the door halfway by
depressing the Door Close button located on the
Foot End Control Panel.
7.
Remove four (4) lag bolts from feet.
8.
The Entree Bath can now be lifted off of the pallet.
The Entree Bath is VERY HEAVY. Two people
(Minimum) are required to move the Entree Bath.
9.
Position the cover panel onto the front of the
Entree Bath and line up the screw holes (Detail 4).
Place one of the 10-
32 x ¾” thumbscrews into each
hole on the cover panel and tighten accordingly.
Door Close
Button
Door Open
Button
Emergency
Door Open
Button
Shock and Tip Tags
