7
6
• The Soapy Water Test must be performed each time the gas cylinder
is connected to your grill or each time the grill is used.
• The Soapy Water Test must be performed outdoors in a well-ventilated
area.
• When performing the Soapy Water Test, always keep grill away from
open flames, sparks, or lit cigarettes. Never use an open flame to test
for gas leaks.
• This product will not operate with natural gas.
PROCEDURE:
1. Turn gas control valve to OFF position, and turn the gas cylinder
valve to the OFF position.
2. Prepare your soapy water solution by combining (1) one part dish
washing liquid with (3) three parts water to test for the possibility of
any gas leaks in the hose or connections to regulator and the
regulator connection to gas cylinder. Apply soapy water solution to the
gas cylinder valve, regulator and up the hose to the grill hose
connection.
3. Turn gas cylinder valve ON (gas control valve is in
the OFF position) and observe gas cylinder valve,
hose and regulator for bubbles. DO NOT LEAVE
GAS ON FOR MORE THAN 12 SECONDS. If
bubbles appear, stop, turn gas cylinder OFF, and
retighten the fitting. Repeat test.
4. When the test is complete, and there are no leaks, wait a minimum of
5 minutes for gas fumes to diminish before lighting cooker.
DURING ANY PORTION OF THE SOAPY WATER TEST, IF BUBBLES
CONTINUE TO APPEAR, STOP, DO NOT USE THE GRILL AND
CONTACT YOUR LOCAL PROPANE DEALER OR MASTERBUILT AT
800-489-1581 NOTE: USE A 20 (9.09 KGS) LB. CYLINDER OR
SMALLER WITH A PROTECTIVE COLLAR WITH THIS GRILL.
Before each use perform soapy water test. Before each use, inspect
gas hose for any signs of abrasion, cuts, leaks, or wear.
If replacement is needed, contact Masterbuilt Manufacturing
for regulator model #BPRSQPG and/or hose model #BPRLP15.
SOAPY WATER TEST WARNING AND PROCEDURES
Bubbles in Soapy Water Test
1.
Read all instructions and warnings before lighting
2.
Check the gas control valve and gas cylinder valve to be certain it
is in the OFF position before connecting to the gas cylinder.
perform soapy water test before each use.
3.
Open lid during lighting
4.
Turn gas control valve OFF, turn gas cylinder valve on
5.
Push down knob and turn to 'ignite' and light
6.
Repeat up to three time if necessary
7.
If ignition does not take place immediately, wait five minutes and
then match light. See match light instructions below.
8.
After each use, first turn the gas control valve off first, then the gas
cylinder valve off. Always allow grill to cool completely before
touching, moving, or storing.
CAUTION: Fatty foods (like hamburgers) can have excess grease and can
cause flair up. When cooking fatty foods, use a low setting with lid open.
BURNER LIGHTING INSTRUCTIONS
1.
Read all instructions and warnings before lighting
2.
Check the gas control valve and gas cylinder valve to be certain it
is in the OFF position before connecting to the gas cylinder.
perform soapy water test before each use.
3.
Open lid during lighting
4.
Turn gas control valve OFF, turn gas cylinder valve on
5.
Push down knob and turn to
low setting
6.
Place a lit fireplace match through
lighting hole in side of grill.
7.
After each use, first turn the gas
control valve off first, then the gas
cylinder off. Always allow grill to
cool completely before touching,
moving, or storing.
MATCH LIGHTING INSTRUCTIONS
WARNING:
Always visually
check burner ignition
to avoid gas leeks.
