Master MAS-F38, Manual

Page: 48 / 59

4
8
EN
4.5 Belt Adjustment
Belt Tension Adjustment
-It is very important for joggers and runners in order to provide a smooth, steady
running surface. Adjustment must be made from the right and left rear roller in order to adjust tension with the
Hexagonal Wrench provided in the parts package. The adjustment bolt is located at the end of the rails as noted in
diagram below:
Note: Adjustment is thru the small hold on the end caps.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and left bolt
clockwise reasonably and inspect for proper tension. When an adjustment is made to the belt tension, you must
also make a tracking adjustment to compensate for the change in belt tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing failure
.
4.6 Belt Tracking Adjustment
This treadmill is designed to keep the belt reasonably centred while in use. It is normal for some belts to drift
near one side while the belt is running with no one on it. After a few minutes of use, the belt should have a
tendency to centre itself. If during use, the belt continues to move toward one side, adjustments are necessary.
The procedures are as below:
▲
First set speed at lowest posi on.
▲ Second check the belt shi s to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using Hexagonal Wrench, until
the belt is centered itself; If belt shifts to left, tighten the left bolt and loosen the right bolt by using 6mm
Hexagonal Wrench, until the belt is centered. When adjusting the belt using the Hexagonal Wrenches, it is
important to adjust the belt in half turn increments. Over adjusting the belt can cause damage to the mat.
Left bolt
Right bolt