Master MAS-F38, Manual

Page: 41 / 59

4
1
EN
18. The pulse sensor is not a medical device. Various factors, including your movement, may affect the accuracy of
heart rate readings. The pulse sensor is intended only as an exercise aid in determining heart rate trends in
general.
19. Do not attempt to raise, lower, or move the treadmill until it is properly assembled. You must be able to safely
lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.
20. When folding or moving the treadmill, make sure that the storage latch is holding the frame securely in the
storage position.
21. Do not change the incline of the treadmill by placing objects under the treadmill.
22. Inspect and properly tighten all parts of the treadmill regularly.
23. Never drop or insert any object into any opening on the treadmill.
24.
DANGER: Always unplug the power cord immediately after use, before cleaning
the treadmill, and before performing the maintenance and adjustment procedures described in this manual. Never
remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than
the procedures in this manual should be performed by an authorized service representative only.
25. This treadmill is intended for in-home use only. Do not use this treadmill in any commercial, rental, or
institutional setting.
26.
WARNING:
If the supply cord is damaged, it must be replaced by the manufacturer,its service agent or similarly qualified perso
ns in order to avoid a hazard.This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities,or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety. Children shoul
d be supervised to ensure that they do not play with the appliance.
27. Install the treadmill on a flat level surface with a suitable volt/Hz which marked in the machine label, grounded
outlet.
28. Allowed temperature: 5 to 40 degrees. If the treadmill has been exposed to cold temperatures,allow it to
warm to room temperature before turning on the power.If you do not do this, you may damage the console
displays or other electrical components.
1.1 IMPORTANT ELECTRICAL INFORMATION
WARNING!

NEVER use a ground fault circuit interrupt (GFCI) wall outlet with this treadmill. Route the power cord away
from any moving part of the treadmill including the elevation mechanism and transport wheels.

NEVER remove any cover without first disconnecting AC power.