Master F-33, Owner'S Manual, Page: 55 / 78

55
EN
3.2 Getting Started
Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the power switch located at
the front of the treadmill below the motor shield. Ensure that the safety key is installed, as the treadmill will not
power on without it. When the power is turned on, all the lights on the display will light for a short time.
3.3 Self-Checking
When using for the first time, it is necessary to make the machine carry on self-check:

Remove the safety key, press MODE and hold, then insert the
safety key again, the machine enters into self-checking state. During this state, pressing START/STOP can
terminate the self-checking.
3.4 Quick-Start Operation
▪
Press and release the START/STOP to wake display up (if not already
on). Note: Installing the safety key will also wake up the console.
▪
Press and release the START/STOP to begin belt movement, at 1.0 Km/hr, then adjust to the desired speed
using the ‘+’ or ‘-’. The speed range is from 1.0km/h to 22.0km/h. You can also use ‘+’ or ‘-’to adjust the
speed on handrail.
▪ To slow the treadmill down, press and hold the ‘
-
’ key to desired speed.
▪
In a state of running, single press START/STOP , the walking belt will gradually slow down if the speed is
above 3.6km/h, if under 3.6km/h, then it will stop immediately.
▪
In the state of running, single press CLEAR will reset all number except the speed. Then enter into manual
mode.
▪
To stop the tread-belt press and release the START/STOP .
3.5 Incline Feature
1. Incline may be adjusted anytime after belt movement.
2. The incline range is from 0 to 20.
3.
Press the ‘up’ or ‘down’ to achieve desired level of effort. You can also adjust the incline percent by
using the ‘+’ or ‘-’ on handrail.
4. The display will indicate incline percent as adjustments are made.
5. Incline will remain in its position when display is turned off.
3.6 Heart Rate Control User Guide
Setting Basic Heart Rate

Turn on treadmill, set heart rate within 6 seconds.

Press “speed up “ or “ speed down “ key to increase or decrease basic heart rate setting value

After setting basic heart rate , press “ start/stop” to confirm

Basic heart rate setting range :100-180