11
Tool Specifications
Auxiliary Handle/Depth Stop
❏
Before any work on the machine itself, pull the
mains plug.
❏
Operate the machine only with the auxiliary
handle 11.
BMH 40-XES:
Loosen the auxiliary handle by turning the knurled
nut
12
anticlockwise.
The auxiliary handle
11
can be set to any position
for a secure and low-fatigue working posture.
The tensioning strap
3
of the auxiliary handle must
remain in the groove
Then, retighten the auxiliary handle by turning the
knurled nut 12 clockwise.
The drilling depth can be set with the depth stop
13
.
For this, press the button for the depth-stop adjust-
ment
10
, adjust the required drilling depth
X
and
release the button again.
The notched groove on depth stop
13
must face
downward
MH 5-XES:
The auxiliary handle
11
can be set to any position
for a secure and low-fatigue working posture.
Loosen the knurled nut
12
, rotate the auxiliary han-
dle 7 around the axis of the machine to the required
position and tighten the knurled nut
12
again.
The auxiliary handle
11
can be mounted to a differ-
ent position. For this, completely unscrew the knurled
nut
12
and then pull out the hexagon bolt upward.
Pull off the auxiliary handle
11
to the side and turn
around the remaining clamping element by 180°.
Mount the auxiliary handle
11
in reverse order.
Changing the Tool
❏
Before any work on the machine itself, pull the
mains plug.
With the SDS-max tool holder, simpler and easier
tool changing is possible without additional aids.
The dust protection cap
1
largely prevents the entry
of drilling dust into the tool holder during operation.
When inserting the tool, take care that the dust pro-
tection cap
1
is not damaged.
❏
A damaged dust protection cap should be
changed immediately. We recommend having
this carried out by an after-sales service.
Inserting
Clean and lightly grease the shank end of the tool.
Insert the tool in a twisting manner into the tool
holder until it latches itself.
Check the latching by pulling the tool.
Removing
Push back the locking sleeve
2
and remove the tool.
Starting Operation
Switching On and Off
MH 5-XES:
To
switch on
the machine, push the On/Off
switch
6
.
To
switch off
the machine, press the On/Off switch
6 again
BMH 40-XES:
To
switch on
the machine, push the On/Off
switch
6
.
To
lock on
the On/Off switch
6
, hold the pressed
switch and additionally slide the lock-on button
7
up. The lock-on function can only be used in chisel-
ling mode. When the lock-on function is activated in
drilling mode, the power tool automatically switches
off for safety reasons.
To
switch off
the machine, press the On/Off
switch
6
again
Rotary Hammer
BMH 40-XES
Demolition Ham-
mer
MH 5-XES
Article number
0702 553 X
0702 563 X
Impact energy
per stroke
1300 W
1300 W
Tool holder
2–12 J
2–12 J
Tool holder
SDS-Max
SDS-Max
Drilling capacity in
concrete
-
Drill bit
- Core bit
12–45 mm
40–100 mm
–
–
Optimal drilling
capacity in concrete
-
Drill bit
25–35 mm
–
Chisel positions
18
18
Weight, approx
6.95 kg
6.2 kg
0702 653 X.book Seite 11 Freitag, 9. Juli 2010 9:37 09
