en
►1.22. Conditions of use:
A) Air temperature: 18°C to 45°C;
Water temperature: <45°C.
B) The air supply must be free
of dust, pollutants, or additional
cleaning should be used.
►►2. UNPACKING
►2.1.
Remove all packaging materials
used to wrap and deliver the appliance
and dispose of them in compliance
with the Standards in force.
►2.2.
Extract all items from the
packaging.
►2.3.
Verify if damage undergone during
transport. If the appliance appears
damaged, inform the dealer, where the
purchase was made, immediately.
►►3. ASSEMBLY
The device is equipped with wheels to
facilitate handling. Depending on the
model, wheels can be found already
installed or not. Components equipped
with relative nuts and bolts are found
inside the packaging (Fig. 1).
►►4. OPERATION
WARNING: Thoroughly read the
”INFORMATION REGARDING
SAFETY”, before switching the
appliance on.
WARNING: Only use clean water to
prevent failures or other anomalies.
WARNING: Verify if your electronic
system is earthed correctly.
Connection to the mains must
be made in compliance with the
National Standards in force. Power
the appliance only with voltage and
frequency as speciied on the data
plate.
On the side of the cooler there are a
series of ittings and taps (Fig. 2-3-4):
►WATER FLOW ADJUSTMENT COCK
(Fig. 2): Used to adjust the water supply
to the cooler. With the cock completely
closed, you will have the maximum
water low.
►DRAIN FITTING-TAP (Fig. 3): Used
to drain the water through the cooler
pump. To empty the tank connect the
drain hose to this itting, enable COOL
mode on the control panel and open
the cock.
►WATER SUPPLY FITTING (Fig. 4):
Used to supply water continuously and
automatically to the cooler. After illing,
the appliance can also be moved,
always with the utmost care.
►►4.1. SWITCH-ON:
►4.1.1.
Connect the hose of the water
supply to the cooler’s itting (Fig. 5).
►4.1.2.
Reilling the water tank. When
the tank reaches the maximum level,
a loat automatically stops the low of
water.
CAUTION: You can operate the cooler
while connected to and continuously
fed by the water supply.
►4.1.3.
Check that there were no leaks
during refuelling.
►
4.1.4.
Connect the supply plug to the
power mains (Fig. 6).
CAUTION: When the supply plug is
connected to the power mains, the
display shows the approximate room
temperature.
►
4.1.5.
Press ON/OFF / POWER to turn
on the device (Fig. 9).
►
►
4.2.1. CONTROL PANEL AND
FUNCTIONS (Fig. 7):
►ON/OFF: Turns on or off the device.
►WIND SPEED: Increases or decreases
the ventilation speed of the device. You
can choose from three speeds.
►COOL: Enables or disables the cooling
mode.
CAUTION: By pressing this button,
ventilation activates after a few
seconds.
Figures and texts of this book are protected by COPYRIGHT.
