Master A3, Manual, Page: 31 / 34

31
EN
2. SWING ACCESSORY
PART NO NAME Q'TY PART NO NAME Q'TY
1 Rope 1 G4 M8 U-Screw 2
2 Swing Seat 2 U2 M8 Safety Nut 4
3 Adjust Lump 2 X2 M8 Iron Washer 4
X4 Clip 4
1 2 3 G4
U2 X2 X4
EXCURSUS:
1: Thread the rope through the holes in the seat making sure that it fits into the gate underneath in the
diagram. The length of rope should be the same on both sides. Tie a knot in the rope on both sides of the
seat as shown in the diagram, with the knots as close as possible to the seat.
2: Fit the ends of the rope through the holes of the adjust lump as shown in the diagrams -through hole
“B”,
back through
“C”, through “D”, then thread under the loop in the rope at the back. Adjust if needed, so that the
seat is level and at the required height. Leave 10 cm rope to seizing by the Clip(X4), as shown in the figure
THE SEAT IS 400-600 MM
HIGH FROM THE GROUND
ASSEMBLE INSTRUCTION OF THE SWING